2. Tighten left-hand side ring nut (1) using special tool
number 9971349 until minimum backlash between the
bevel teeth is 1.000 mm (0.039 in).
3. Measure the backlash using dial gauge and magnetic
stand as shown in figure. Backlash to keep in between
0.180 - 0.230 mm (0.007 - 0.009 in).
4. Measure the torque using a spring balance and chord
wound around the sleeve of low gear it should be be-
tween 4.00 - 5.50 kgm (28.93 - 39.78 ftlbs).
5. Fit the lock plate (1) back on bearing support ap-
ply thread lock sealant L
screws.
Rear axle system - Rear bevel gear set and differential
® 243™ to the Allen
OCTITE
47866583_ 02/12/2015
27.2 [27.106] / 20
4
GNIL14TR04272AB
5
GNIL14TR04273AA
6
GNIL14TR04274AA
7
GNIL14TR04275AA