Final drive housing - Assemble
Reinstall wheel and axle shaft in final drive housing
observing the following:
• Re assembling follows the removal procedure. See
Final drive housing - Disassemble (27.120).
• Refer to figure for correct orientation of the shafts
bearings sleeves and seals.
• Check seals and replace if damaged.
• Fit final drive housing oil seal back, by using the spe-
cial tool number 84261386.
• Check planet carrier after fitting circlip lock on axle
for free play. If notice any free play remove circlip
lock and place suitable shim below the spacer, so as
to eliminate free play completely.
NOTE: In low duty trumpet housing bearing preload
is not required.
• Before reassembling housing and covers thoroughly
clean and de-grease mating surfaces and apply a
2.00 mm (0.08 in) bead of sealant following the pat-
tern shown in the figure.
Rear axle system - Planetary and final drives
GNIL14TR04294FA
47866583_ 02/12/2015
27.3 [27.120] / 12
3
1
GNIL14TR04292AB
2
GNIL14TR04293AA