Bevel pinion - Remove
WARNING
Avoid injury!
Handle all parts carefully. Do not place your hands or fingers between parts. Use Personal Protec-
tive Equipment (PPE) as indicated in this manual, including protective goggles, gloves, and safety
footwear.
Failure to comply could result in death or serious injury.
To remove the pinion shaft, it is necessary to remove
the transmission housing, from the tractor following the
procedure described under transmission assembly re-
moval installation. Also it is required to remove Power
Take-Off (PTO) cover and related components.
1. Remove the driven shaft, drive shaft and range shaft
before dismantling pinion shaft.
2. 1. To remove the crown wheel loosen set screws (1)
from the cover plate.
2. Remove crown wheel along with cover plate, retrieve
rubber ring from the housing.
3. Remove the crown wheel along with differential hous-
ing.
Rear axle system - Rear bevel gear set and differential
47866583_ 02/12/2015
27.2 [27.106] / 21
W0208A
1
GNIL14TR04069AA
2
GNIL14TR04070AB
3
GNIL14TR04071AA