New Holland WorkMaster 50 Service Manual page 756

Electrical systems - FAULT CODES
DTC 137-03-Fuel pressure relief valve is open
Control Module : ECU
NOTE: If the Pressure Relief Valve (PRV) is replaced, it is necessary to perform the Replacement of the Rail Pressure
Relief Valve (PRV) - Reset ECU Data with the Electronic Service Tool (EST) before you return the machine to service.
See Common rail Relief valve - Configure - Reset ECU data (10.218), if necessary.
NOTE: If the rail pressure sensor B-9004 is replaced, it is necessary to perform the Replacement of the Rail Pressure
sensor - Reset ECU Data with the Electronic Service Tool (EST) before you return the machine to service. See
Common rail pressure sensor - Configure - Reset ECU data (Rail pressure sensor) (55.010), if necessary.
Context:
The Engine Control Unit (ECU) A-9000 monitors the Pressure Relief Valve (PRV). If the ECU A-9000 commands the
PRV to open by a pressure shock, this fault will occur. Other active faults may have caused this fault to occur. For
more information regarding fuel system troubleshooting, see Fuel injection system - Troubleshooting (10.218).
Cause:
The ECU A-9000 has determined that the PRV is open.
Possible failure modes:
1. Faulty fuel metering unit Y-9000, stuck open.
2. Faulty fuel injectors.
3. Faulty rail pressure sensor B-9004, drifted signal.
4. Faulty PRV, opening pressure too low.
5. Faulty fuel back-flow, clogged or damaged.
6. Faulty ECU A-9000, software.
47866583_ 02/12/2015
55.12 [55.DTC] / 35