16. Place the end cover in position.
17. Fit the special screw with washer and place it in the
hole (1).
18. Fit the six screws with washers and insert them.
Cross-tighten all the screws and the rolled pin with
a torque of 3.0 ± 0.6 daNm. The steering motor can
now be function tested.
19. Fit the dust seal ring in the housing using suitable tool
and a plastic hammer.
Steering - Hydraulic control components
47866583_ 02/12/2015
41.2 [41.200] / 21
33
GNIL14TR04540AA
34
GNIL14TR04541AB
35
GNIL14TR04542AA
36
GNIL14TR04543AA