New Holland WorkMaster 50 Service Manual page 103

Clutch - Disassemble
WARNING
Avoid injury!
Handle all parts carefully. Do not place your hands or fingers between parts. Use Personal Protec-
tive Equipment (PPE) as indicated in this manual, including protective goggles, gloves, and safety
footwear.
Failure to comply could result in death or serious injury.
1. Remove the clutch assembly from the tractor as de-
scribed earlier in this section. See Clutch - Remove
(18.110).
2. Loosen the Power Take-Off (PTO) clutch release lever
locknuts (1).
NOTICE: Since the locknuts are under the load of disk ring,
loosen all these gradually and evenly by rotating 1/4 to 1/2
turns.
3. Remove Power Take-Off (PTO) pressure plate (1).
4. Remove disk ring (1) and lock ring (2).
Clutch - Clutch and components
47866583_ 02/12/2015
18.2 [18.110] / 10
W0208A
1
GNIL14TR04695AB
2
GNIL14TR04696AB
3
GNIL14TR04697AB