New Holland WorkMaster 50 Service Manual page 321

4. Remove the check chain and lower link of the three
point linkage.
5. Remove the ROPS (Roll Over Protective Structure).
NOTE: Use a suitable hoist.
6. 1. Wrap chain around final drive housing and loosen
bolts (1).
2. Remove the final drive housing.
7. Place the trumpet housing assembly on plane surface.
Rear axle system - Planetary and final drives
47866583_ 02/12/2015
27.3 [27.120] / 6
4
GNIL14TR00864AA
5
GNIL14TR00865AA
6
GNIL14TR04276AB
7
GNIL14TR04336AA