New Holland WorkMaster 50 Service Manual page 492

10. Take care to keep the cross pin in the sleeve and spool
horizontal. The pin can be seen through the open end
of the spool. Press the spool inwards and the sleeve,
ring, bearing races and needle bearing will be pushed
out of the housing together.
11. Take ring, bearing races and needle bearing from
sleeve and spool. The outer (thin) bearing race can
sometimes "stick" in the housing, therefore check that
it has come out.
12. Press out the cross pin. Use the special screw from
the end cover.
NOTE: A small mark has been made with pumice stone on
both spool and sleeve close to one of the slots for the neu-
tral position springs (see figure). If the mark is not visible,
remember to leave a mark of your own on sleeve and spool
before the neutral position springs are dismantled.
Steering - Hydraulic control components
47866583_ 02/12/2015
41.2 [41.200] / 7
9
GNIL14TR04500AA
10
GNIL14TR04501AA
11
GNIL14TR04502AA
12
GNIL14TR04503AA