New Holland WorkMaster 50 Service Manual page 537

Locations
AC
BD
CE
DF
EG
FH
4. Tighten the nuts on the axle extension securing bolts to
118 N·m (87 lb ft).
With both front wheels parallel, install the locating bolt
(2) in the nearest aligning notch in the tie rod. Tighten
the nut on the locating bolt to 24.5 N·m (18 lb ft).
NOTE: The tread settings shown are approximate. The
front wheel discs are off-set, relative to the center line of
the rim. The tread settings in the table are with the dished
side of the wheel nearest the axle hub. If the front wheels
are reversed on the hubs the tread settings shown in the
table will be increased by approximately 25 mm (0.98 in).
Tractor model
NOTE: Re-check all torque settings after 50 h of operation.
Tie rod
5. The tie rod located behind the axle must be disengaged
to permit adjustment of the axle. The tie rod is tele-
scopic and consists of a central hollow tube with a solid
extendible section at each end. Remove the locating
bolt (1) from both ends of the tie rod. The position
for the setting of the steering cylinder will also change
respectively. Reset the left and right axle telescopic
sections, passing the securing bolts through the center
beam and telescopic sections, as indicated in 3, see
chart.
6. Remove the nut (1) at the right end of the tie rod. With-
draw the tie rod from arm (2). Loosen the bolt (3) and
rotate the threaded end to shorten or lengthen the tie
rod assembly until the toe-in is correct. Torque all bolts
or nuts securely to correct values.
Wheels - Front wheels
Securing
Bolt
1472 mm
1572 mm
1672 mm
1772 mm
1872 mm
1972 mm
320.0 N·m (236.0 lb ft)
47866583_ 02/12/2015
44.1 [44.511] / 6
2WD
Front wheel bolt torque
4
86090130N
5
20108792