New Holland WorkMaster 50 Service Manual page 994

Use EST to check to see that this fault has been resolved.
A. If the fault has been resolved, return the machine to service.
B. If this fault has not been resolved, check the ECU A-9000 for the appropriate software and re-flash, if necessary.
5. Visually inspect the relevant harnesses and connectors for damage, bent or dislocated pins, corroded terminals,
or broken wires. Verify that the connectors are fully installed. Flex the harnesses involved to reveal intermittent
breaks or shorts in the wiring concerned. Operate the machine while you monitor the display.
A. If you find damage or the display indicates other than normal display readings, then repair the damage discov-
ered during the inspection or locate and repair the other than normal display condition and verify that the error
has been resolved.
B. If you do not find damage and the display indicates only normal readings, then erase the fault code and continue
operation.
Wiring harnesses - Electrical schematic sheet 02 (55.100)
Electrical systems - FAULT CODES
47866583_ 02/12/2015
55.12 [55.DTC] / 273