New Holland WorkMaster 50 Service Manual page 689

Turn signal and/or hazard lights - Replace
Stop/Turn/Position lights, bulb replacement
The bulbs are accessible after removal of the plastic
lenses assembly. Remove the two screws (1) and take
out the lens assembly (2). The bulbs can be removed
by pressing in and turning approximately 20 degree
counterclockwise. Reassemble in reverse order.
Tail light (3) and flasher/turn signal light (4)
NOTICE: When replacing the lenses, take care not to over-
tighten the retaining screws.
Bulb Size
• Tail Light - #1157
• Flasher/Turn Signal - #1156
Electrical systems - External lighting
47866583_ 02/12/2015
55.8 [55.404] / 4
1
20108813
2
20108814