New Holland WorkMaster 50 Service Manual page 376

Mechanical service brakes - Install
NOTE: Always use suitable tools to align holes. Do not use hand or fingers.
1. Reinstall the brake assembly and rear axle housing to
the differential housing taking the following into consid-
eration.
• Reassembly follows the disassembly procedure in
reverse, form step 5 back to step 1.
• Refer to figure to orient the different parts.
• Use special tool number 84261390 to fit the brake
rubber boot in the brake linkage groove and
brake rubber brake boot with special tool number
84261391 in trumpet housing.
• Before reinstalling the rear axle housing, thoroughly
clean and degrease mating surfaces and apply a
bead of liquid gasket of approx. 2.000 mm (0.079 in)
of diameter.
• Check seals for wear and damage and replace if
necessary.
• Tighten to correct torques.
After brake assembly fitted in differential housing, check
brake discs for free movement between brake discs.
Brakes and controls - Mechanical service brakes
47866583_ 02/12/2015
33.1 [33.120] / 13
1
GNIL14TR04340AA
2
GNIL14TR04341AA