New Holland WorkMaster 50 Service Manual page 274

Front axle - Remove – Spindle Assembly
WARNING
Avoid injury!
Handle all parts carefully. Do not place your hands or fingers between parts. Use Personal Protec-
tive Equipment (PPE) as indicated in this manual, including protective goggles, gloves, and safety
footwear.
Failure to comply could result in death or serious injury.
Swivel pins can be removed and overhauled with the
front axle on the tractor proceed as follows for each
wheel:
1. Safely block rear wheels.
2. Jack up front tractor and place a stationary stand (1)
under the sump.
3. Loosen retaining bolts and remove front wheels.
4. Remove swivel pin control lever retaining bolt (1).
5. Slide out the control lever (2) from the spindle assem-
bly.
6. Pull out the swivel axle and hub assembly (1) from axle
outer section.
Front axle system - Non-powered front axle
47866583_ 02/12/2015
25.5 [25.400] / 11
W0208A
1
GNIL14TR04449AB
2
GNIL14TR04450AB
3
GNIL14TR04451AB