New Holland WorkMaster 50 Service Manual page 227

Four-Wheel Drive (4WD) axle - Install
CAUTION
Pinch hazard!
Always use suitable tools to align mating parts.
DO NOT use your hand or fingers.
Failure to comply could result in minor or mod-
erate injury.
1. Refit the front axle following the instructions below.
• Install the axle and bolt the front and rear supports
in position.
• Reconnect the power steering hoses.
• Install the front wheels.
• Raise the front of the tractor using the hoist.
• Remove the fixed stand.
• Detach the nylon cables.
• Reconnect the drive shaft and install the drive shaft
guard.
• Attach a nylon cable to the front weights, lift, install
to the tractor and secure with the locking screws.
• Reconnect the negative battery lead.
• See the Four-Wheel Drive (4WD) axle - Torque
(25.100).
Front axle system - Powered front axle
C0044A
47866583_ 02/12/2015
25.1 [25.100] / 18