5. Remove the internal retaining ring with screw driver.
6. Remove the head hammering the rod. Remove the
piston after unscrew the self locking nut.
NOTE: Check that oil ports are not plugged and remove
internal oil.
7. Extract the rod by pulling. Seal on the piston could
require energetic action. Clamp the rod paying special
attention to not scratch its surface.
8. Remove with the screw driver piston seal and O-ring
under the seal.
9. Throw away used seal and open the seal kit and clean
the piston.
10. Apply piston seal mounting bell against piston and in-
sert the O-ring having it slipping on the bell.
Steering - Cylinders
47866583_ 02/12/2015
41.4 [41.216] / 5
3
GNIL14TR04547AA
4
GNIL14TR04549AA
5
GNIL14TR04550AA
6
GNIL14TR04551AB