New Holland WorkMaster 50 Service Manual page 178

5. Remove the driven shaft (1) from the housing.
NOTE: 3rd and 4th gears are a integral part of the driven
shaft.
6. Clean and inspect the gears and hub for excess wear,
chipped gear teeth, cracks or any other damage. Re-
place as necessary.
7. Inspect the shift fork for wear or damage. Replace as
necessary.
8. Inspect the shift rail for wear or damage. Replace as
necessary.
Range shaft removal
9. Remove the circlip lock (1) of the range shaft.
10. Remove the range shaft (1) from the housing. Re-
move the oil feeder cup (2) from the shaft as shown.
11. After removing the high low rail take out high low fork
(1).
NOTE: It is required to take out the spacer (2), spring and
ball of high low rail shaft from the housing.
Transmission - Gearbox internal components
47866583_ 02/12/2015
21.4 [21.145] / 15
5
GNIL14TR04178A
6
GNIL14TR04065AB
7
GNIL14TR04066AB
8
GNIL14TR04067AB