New Holland WorkMaster 50 Service Manual page 348

One-speed rear Power Take-Off (PTO) - Overview
The Power Take-Off (PTO) transfers engine power di-
rectly to mounted, semi-mounted or trailed equipment via
a splined shaft at the rear of the tractor.
The system utilizes the standard 6 -splines shaft designed
to operator at 540 RPM, the speed at which most Power
Take-Off (PTO) driven equipment is designed to run.
The Power Take-Off (PTO) input shaft front end can be
connected and disconnected to the transmission input
shaft by means of a lever (1) on the left hand-side of the
transmission unit.
Move the lever (1) backward to engage the PTO. Move
the lever (1) forward to disengage the PTO.
The rear end of the Power Take-Off (PTO) input shaft
is connected to the Power Take-Off (PTO) output shaft
through reduction gears.
The standard speed of 540 PTO RPM can be obtained at
2575 engine rpm.
DANGER
To avoid inadvertent movement of the implement,
disengage the Power Take-Off (PTO) after each use
WARNING
Whenever operating Power Take-Off (PTO) equipment,
observe the following precautions:
Power Take-Off (PTO) - One-speed rear Power Take-Off (PTO)
47866583_ 02/12/2015
31.2 [31.110] / 3
1
GNIL14TR04298AB