New Holland WorkMaster 50 Service Manual page 313

Bevel pinion - Install
1. Install the bearing on pinion.
2. Fit the outer cone of Gama Bassa bearing and fit circlip
lock.
3. Fit pinion shaft along with hub range, sliding sleeve,
bush and low gear as shown.
NOTE: Fit small spacer keeping cuts towards pinion teeth
side, also big spacer cut towards similarly.
NOTE: Keep deep portion of low gear hub, towards pinion
check nut side. After fitment check low gear it should rotate
free.
4. After fitting pinion, tighten pinion check nut at 28 kgm
(203 ftlbs.) and check pinion bearing preload by wrap-
ping a cord around low gear hub with the help or spring
balance it should be 2.5 - 3.0 kgm (18.1 - 21.7 ftlbs.).
NOTE: If recommended preload not comes, hammer pin-
ion using aluminium rod lock pinion check not, and check
again.
Rear axle system - Rear bevel gear set and differential
47866583_ 02/12/2015
27.2 [27.106] / 24
1
GNIL14TR04078AB
2
GNIL14TR04079AA
3
GNIL14TR04080AA
4
GNIL14TR04081AA