New Holland WorkMaster 50 Service Manual page 231

19. Remove the retaining bolts (1) of the lower pivot pin
of the stub axle housing.
20. Remove the lower pivot pin and the relative adjust-
ment shims.
21. Remove the retaining bolts of the upper pivot pin.
22. Remove the upper pivot pin (1).
23. Remove the stub axle housing (2).
24. Remove the retaining bolt (1) of the axle shaft (2).
25. Using a pry bar, pull the axle shaft out of the casing.
26. To disassemble the right-hand final drive unit, re-
peat the above steps [Invalid Reference] to [Invalid
Reference].
Front axle system - Powered front axle
47866583_ 02/12/2015
25.1 [25.100] / 22
13
GNIL14TR04380AB
14
GNIL14TR04381AB
15
GNIL14TR04382AB
16
GNIL14TR04383AA