New Holland WorkMaster 50 Service Manual page 358

Two-speed rear Power Take-Off (PTO) - Assemble
Power Take-Off (PTO) shaft assembly
Re-install Power Take-Off (PTO) shaft assembly in dif-
ferential housing observing the following:
• Re-assembling follows the disassembly procedure in
reverse. Refer to Two-speed rear Power Take-Off
(PTO) - Disassemble (31.114).
• Refer to figure for correct orientation of the gears and
sleeve.
• Check seals and replace if damaged. Fit the Power
Take-Off (PTO) oil seal in the Power Take-Off (PTO)
rear cover with the help of special tool number
84261386
• Before reassembling Power Take-Off (PTO) cover,
Thoroughly clean and degrease mating surfaces and
apply a 2.00 mm (0.08 in) bead of sealant following
the pattern shown in 2
• Tighten the rear cover bolts to 50 N·m (37 lb ft).
NOTE: Keep bigger collar of the gear toward bearings.
Power Take-Off (PTO) - Two-speed rear Power Take-Off (PTO)
1
GNIL14TR04318AA
47866583_ 02/12/2015
31.3 [31.114] / 7