New Holland WorkMaster 50 Service Manual page 276

Front axle - Overhaul – Spindle Assembly
1. Fix the axle outer section in a vice and remove the
upper seal using suitable tool.
2. Remove the bottom seal using suitable tool and recover
thrust washer.
3. Check the swivel bearing bushes for wear. See spec-
ifications in Non-powered front axle - General spec-
ification (25.400). If bushes require replacement, re-
move the bushes using suitable tool.
4. Using a suitable drift install new bushings on the axle
outer section.
5. Check the swivel pin for wear. If required replace new
spindle.
6. Ream the new bushings to suit the swivel pin.
Front axle system - Non-powered front axle
47866583_ 02/12/2015
25.5 [25.400] / 13
1
GNIL14TR04454AA
2
GNIL14TR04455AA