New Holland WorkMaster 50 Service Manual page 182

Driven shaft - Remove
1. Remove the bottom shift rail (1).
NOTE: The bottom shift rail has a M12 plug (2) that must
be removed from the front of the housing.
2. Remove the 1st gear (1) off the synchromesh driven
shaft.
3. Remove the snap ring (1) from the driven shaft. Take
out the 1st/2nd gear shift fork (2), the 1st/2nd gear cou-
pler (3), and the hub (4) of the driven shaft.
NOTE: Keep the face of the hub with the cut towards the
pinion side.
4. Remove the snap ring (1) that secures the 2nd gear.
Transmission - Gearbox internal components
47866583_ 02/12/2015
21.4 [21.145] / 19
1
GNIL14TR04169AB
2
GNIL14TR04170AB
3
GNIL14TR00867AA
4
GNIL14TR04172AB