New Holland WorkMaster 50 Service Manual page 91

Clutch mechanical release control - Adjust
Clutch pedal free play should be 30.00 - 45.00 mm
(1.18 - 1.77 in). To adjust the clutch pedal free play
proceed as follows:
1. Remove the split pin (1) and disconnect the linkage.
2. Loosen the lock nut (2).
3. Rotate the yoke (3) clockwise to reduce the play and
anti-clockwise to increase the play.
4. Connect the linkage back to the cross shaft.
Power Take-Off (PTO) clutch lever free play (double speed )
1. Remove the pin (2), fork (3) and rod (5) separately.
2. Keep lever (1) at the right most position such that the
bearing just touches the clutch fingers.
3. Insert rod (5) into fork (6) and tight the threads up to
15.00 mm (0.59 in).
4. Keep end of lever (7) at 30.00 - 35.00 mm (1.18 -
1.38 in) from edge as shown in figure.
5. Keep the rod in static position and insert fork (3) into
rod (5).
6. Match the hole of fork (3) with hole of lever (1). Keep
the lever in initial position.
7. Insert pin (2) in matching holes and lock lever (1).
Clutch - Clutch mechanical release control
47866583_ 02/12/2015
18.1 [18.100] / 8
1
GNIL14TR04687AA
2
GNIL14TR04688AB
3
GNIL14TR04690FB