9. Place a new pin in the same two holes.
10. Grease the O-ring with mineral oil approximately vis-
cosity 500 mm2/s at 20 °C (68 °F).
11. Place the distributor plate so that the channel holes
match the holes in the housing.
12. Guide the cardan shaft down into the bore so that the
slot is parallel with the connection flange.
Steering - Hydraulic control components
47866583_ 02/12/2015
41.2 [41.200] / 19
25
GNIL14TR04538AA
26
GNIL14TR04532AA
27
GNIL14TR04533AA
28
GNIL14TR04534AA