New Holland WorkMaster 50 Service Manual page 172

11. Install the shuttle coupler gear assembly (1) over the
input shaft.
12. Secure the shuttle coupler gear on the input shaft with
the external snap ring (2).
13. Press the ball bearing (1) into the cluster gear shaft
(2).
14. Install the cluster gear shaft (2) into the ball bearing
installed from step 2.
15. Apply petroleum jelly to the O-rings (1).
16. Insert the O-rings in the grooves on the shaft link rod
(2).
17. Insert the shaft link rod (1) through the hole in the
clutch housing.
18. Insert the lever link rod (2) in the shift fork (4).
19. Slide the shaft link rod (1) into the lever link rod (2).
20. Align the holes in the shaft link rod (1) with the holes
in the lever link rod (2). Secure using the roll pin (3).
Transmission - Gearbox internal components
47866583_ 02/12/2015
21.4 [21.145] / 9
5
GNIL14TR04215AB
6
GNIL14TR04216AB
7
GNIL14TR04217AB
8
GNIL14TR04218AB