Dhcp Pool Command Set - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
DHCP P C
OOL
To activate the DHCP Pool mode, enter the ip dhcp-server pool command at the Global Configuration
mode prompt. For example:
>enable
#configure terminal
(config)#ip dhcp-server pool MyPool
(config-dhcp)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
client-identifier <identifier>
client-name <name>
default-router <address> <secondary>
dns-server <address> <secondary>
domain-name <domain>
hardware-address <hardware-address> <type>
host <address> [<subnet mask> or <prefix length>]
lease <days> <hours> <minutes>
netbios-name-server <address> <secondary>
netbios-node-type <type>
network <address> [<subnet mask> or <prefix length>]
ntp-server <ip address>
option <option value> [ascii | hex | ip] <value>
tftp-server <server>
timezone-offset <offset>
61200510L1-35E
S
OMMAND ET
on page 1328
on page 1330
on page 1331
on page 1332
on page 1333
on page 1337
on page 1339
on page 1341
on page 1343
on page 1344
Copyright © 2005 ADTRAN
on page 1334
on page 1336
on page 1338
on page 1340
on page 1342

DHCP Pool Command Set

1327