Router (Ospf) Configuration Command Set - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
R (OSPF) C
OUTER
To activate the Router (OSPF) Configuration mode, enter the router ospf command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router ospf
(config-ospf)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 32
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
area <area id> default-cost <value>
area <area id> range <ip address> <network mask> [advertise | not-advertise]
area <area id> stub [no-summary]
auto-cost reference-bandwidth <rate>
default-information-originate [always | metric <value> | metric-type <type>]
default-metric <value>
maximum paths <number>
network <ip address> <wildcard> area <area id>
redistribute connected [metric <value> | metric-type <type> | subnets]
redistribute rip [metric <value> | metric-type <type> | subnets]
redistribute static [metric <value> | metric-type <type> | subnets]
summary-address <address> <mask | prefix mask> not-advertise
timers lsa-group-pacing <seconds>
timers spf <delay> <hold>
61200510L1-35E
ONFIGURATION
on page 1302
on page 1304
on page 1305
on page 1307
on page 1308
on page 1314
on page 1315
Copyright © 2005 ADTRAN

Router (OSPF) Configuration Command Set

C S
OMMAND ET
on page 1309
on page 1310
on page 1311
on page 1312
on page 1313
on page 1303
on page 1306
1301