Gps Configuration; Satellite Status - NetComm NTC-223 User Manual Appendix

Optional gps functionality

Hide thumbs Also See for NTC-223:

Table of Contents

GPGSA – Overall satellite data

GPVTG – Vector track and speed over the Ground

Note – Mobile Station Based Assisted GPS is not supported on the NTC-223 with the Navisys GR-701U GPS Receiver.

GPS configuration

To activate the GPS functionality, log in to the NTC-223 user interface and select Services from the top menu, then

click GPS and select GPS Configuration from its submenu.

Move the GPS operation toggle switch to ON and click the Save button to enable ongoing GPS services.

Once enabled, the GPS antenna will begin scanning for satellite signals. The number detected will depend on the

NTC-223's location on earth as well as the location of the antenna receiver and whether or not the signal is

obstructed or interfered with.

It may take a number of minutes before enough satellites are detected for the GPS service to be established.

Optional GPS functionality on NTC-223 – User Guide Appendix

UG01192 v1.0 20 August 2019

Figure 3 – Enable GPS operation

Figure 4 – Satellite status display

7 of 13

Table of Contents