Configuring The Wan Interface - Avaya IG550 Installing And Configuring

8. Click the vp-1/0/0 Logical Interface Name.
The Interface Information screen appears.
9. In the IPv4 Address Prefix field, type <internal_ip_address>/32, where
<internal_ip_address> is the address, also known as the "source" address,
router uses to establish a continuous point-to-point communication session to the TGM550.
This session is used for passing control signals and data packets back and forth between
the router and the TGM550 and allows an administration access connection from the
TGM550 to the router using the session chassis command.
Note:
<internal_ip_address> should be a private IP address and should always
Note:
be followed by the /32 32-bit subnet mask designation.
10. In the Destination Address field, type the "destination" IP address, which is used by any
other devices over the network for sending data to the TGM550 and for accessing the
TGM550, including access to the TGM550 CLI interface.
11. Click Apply. Then click OK.

Configuring the WAN interface

See the Juniper J-series Services Router Basic LAN and WAN Access Configuration Guide for
procedures on how to configure an E1, T1, E3, or T3 WAN interface.
that the
Issue 2 January 2008 73