Table of Contents
Advertisement
*OPC?
*OPT?
*RST
*SRE[?]
*STB?
*TST?
Keysight M8131A 16/32 GSa/s Digitizer User's Guide
Return "1" to the output buffer after the previous commands have been
completed. Other commands cannot be executed until this command
completes.
Read the installed options. The response consists of any number of fields
separated by commas.
Reset instrument to its factory default state.
Enable bits in the Status Byte to generate a Service Request. To enable
specific bits, you must write a decimal value which corresponds to the
binary-weighted sum of the bits in the register. The selected bits are
summarized in the "Master Summary" bit (bit 6) of the Status Byte
Register. If any of the selected bits change from "0" to "1", a Service
Request signal is generated. The *SRE? query returns a decimal value
which corresponds to the binary-weighted sum of all bits enabled by the
*SRE command.
Query the summary (status byte condition) register in this register group.
This command is similar to a Serial Poll but it is processed like any other
instrument command. This command returns the same result as a Serial
Poll but the "Master Summary" bit (bit 6) is not cleared by the *STB?
command.
Execute Self Tests. If self-tests pass, a 0 is returned. A number lager than 0
indicates the number of failed tests.
To get actual messages, use :TEST:TST?
Remote Programming
139
7
Advertisement
Table of Contents
