Dut Parameters - Keysight Technologies N5990A User Manual

2 N5990A M-PHY Station

DUT Parameters

Parameter Name
Product
Product Number
Serial Number
Product Type
Test Type
Description
Num of Channels
Protocol
Test
User Name
Comment
Initial Start Date
Last Test Date
Compliance Mode
40
The DUT Parameters are listed below in
Table 1 DUT Parameter List
Parameter Description
The selected name will be used to identify the product when the "Database Offline" option is selected.
The selected serial number will be used to identify the product when database option is selected.
The product type can be selected as:
• Receiver
• Transmitter
If Receiver is selected, the main window will display the set of tests corresponding to receiver testing:
HS-RX, PWM-RX, SYS-RX and SQ-RX tests.
If Transmitter is selected, the main window will display the set of tests corresponding to the transmitter
testing:
HS-TX, PWM-TX and SYS-TX tests.
By default, the test type is set to Phy Test: physical layer test.
A description of the DUT ca be added.
Here, you can select the number of DUT input channels (Receiver tests) or output channels (Transmitter
tests) to be tested.
• M8020A allows to test up to 4 channels.
• N4903B allows to test up to 2 channels. When used together with the Bitifeye 2100 Switch, up to 4
channels can be tested.
It can be selected as follows:
• DigRFv4
• LLI (Low Latency Interface)
• UniPro (Unified Protocol)
• SSIC (Super Speed Inter Chip)
• PCIe (PCI Express)
• UFS (Universal Flash Storage
A user name can be added to the test information.
A comment can be added to the test information.
Time stamp of the start of the current test session.
Time stamp of the last test conducted in the current session.
In this mode, the tests are conducted as mandated by the CTS, the test parameters used in the calibration
and test procedures are shown but cannot be modified by the user.
Table 1.
Keysight N5990A MIPI M-PHY Receiver Test User Guide