Parameters - Keysight Technologies N5990A User Manual

Parameters

Keysight N5990A MIPI M-PHY Receiver Test User Guide
Figure 133 Connection Diagram for Receiver Squelch Tests (for N4903B + DSGA)
The parameters used in Expert Mode for this test, are as follows:
• Data Rate
• CDR Loop Bandwidth (if CDR is selected in the Special Parameter
dialog, see "BERT Analyzer
• CDR Peaking (if CDR is selected in the Special Parameter dialog, see
"BERT Analyzer Settings")
• CDR Transition Density (if CDR is selected in the Special Parameter
dialog, see "BERT Analyzer
• CDR Loop Order (if CDR is selected in the Special Parameter dialog,
see "BERT Analyzer
• Target BER
• IBerReader Init Mode
• Squelch Test Sequence
• Re-Init sequence after Reset DUT
• Min Value
• Max Value
• Step Size
Settings")
Settings")
Settings")
Squelch Tests 6
219