Table of Contents
Advertisement
Shown below are all parameters (columns) for an RCal calibration state (row):
RCal Configuration Table – Parameters
The following table details the parameters for each column in every calibration row.
Column Title
Calibrate
(checkbox)
Apply
(checkbox)
Name
Last Calibrated
Applied
Ext Mixer
Type
U9361C/F/G/M RCal Receiver Calibrator Measurement Guide
Description
Rows that are selected will be included when
Calibrate Checked Rows is used to start a
calibration.
Rows that are successfully calibrated will be
applied to measurements when selected.
User defined row name.
(Read only) Date and time that last calibration
was successfully executed.
(Read only)
"Yes" if successfully applied, "---" if not yet
calibrated, and "No" if not applied.
(Read only)
Applies only if Input = Ext Mixer
Magnitude: Select for correcting magnitude
only (no phase corrections). Use for swept
measurements.
Complex: Select for correcting magnitude and
phase. Use for correcting IF responses for IQ
demodulation measurements.
RCal Software – Configuration
Additional Information
Complex is only available if RCal Option
CPX is installed.
11
Advertisement
Table of Contents
