Keysight Technologies N5990A User Manual page 47

Wildcard
[Type]
[LsGear]
[HsGear]
[Mode]
[Amplitude]
[Channel]
[Terminated]
Keysight N5990A MIPI M-PHY Receiver Test User Guide
Figure 17
Wildcards
A wildcard is an expression or symbol that is used especially to represent
any value when selecting specific file names or directories. This section
refers to the wildcard's availability in the N5990A M-PHY for the sequence
file names selected in the Select M-PHY Sequences panel (see
The default sequence names do not use wildcards and are used for all
tests and setup procedures with out applying a change. If a wildcard
sequence name is provided, the sequence name is replaced with different
names during run time depending on the test specifics. It is your
responsibility to provide such sequence files in the M-PHY pattern
directory (by default C:\ProgramData\BitifEye\N5990A\Pattern\MPhy).
The supported wildcards are as listed below in
mandatory).
Table 2
Values
RX, TX
PWM1, PWM2, PWM3,..PWM7
Gear1A, Gear1B,...Gear3B
Cont, Burst
Large, Small
Data0, Data1, Data2, Data3, and DataAll
RT, NT
Select M-PHY Sequences panel
Supported Wildcards
N5990A M-PHY Station
Figure
Table 2 (none are
2
17).
47