Keysight Technologies N5990A User Manual page 59

Keysight N5990A MIPI M-PHY Receiver Test User Guide
Figure 28 M8020 ISI dialog
The preset can be selected as:
• Physical Trace: In this case the ISI is not generated internally with the
M8020. The ISI is added by including physical traces in the setup.
• MPHY G3A Ch1, MPHY G3A Ch2, MPHY G3B Ch1, MPHY G3B Ch2,
MIPI Short, MIPI Standard and MIPI Long are pre-defined presets of the
M8020.
• Custom: The preset is defined by selecting the following properties:
• Mode: Two pairs Frequency/Insertion Loss must be defined to
characterize the preset.
• If One Point mode is selected, the first point is pre-defined as
0Hz/0dB.
• In Two Point mode, the two Frequency/Insertion Loss points
can be defined.
• Slope: It depends on the points defined. It must be between -6,00dB
and -0,01dB.
• Insertion Loss Offset: It is the insertion loss at 0Hz.
• Frequency 1: First frequency point.
• Insertion Loss 1: Insertion loss applied to the first frequency point.
• Frequency 2: Second frequency point.
N5990A M-PHY Station 2
59