8
Sys Burst Tests
Results
Parameter Name
Result
Amplitude
Offset
Min Passed Offset
Min Spec Offset
276
•
Reference Clock Calibration
•
Level Calibration Terminated / Into Open
An example of a HTML Viewer for the Test 2.3.3-SYS-RX Common Mode
Input Voltage Amplitude Tolerance test procedure is shown in
The results comprise of the following:
•
The common parameter list (in Expert Mode).
•
A test data table (Refer to
Figure 160
Example HTML Viewer for Test 2.3.3-SYS-RX Common Mode Input Volt-
age Amplitude Tolerance Test
Table 50
Test 2.3.3-SYS-RX Common Mode Input Voltage Amplitude Tolerance Test data table
Parameter Description
"Pass"/"Fail" - If the value is "Fail", the amplitude tolerance is below the spec limits.
It is the amplitude value to be tested.
It is the offset value to be tested.
It is the minimum offset value, where the DUT works without errors.
It is the minimum offset value, where the DUT must work successfully.
Table
50).
Keysight N5990A MIPI M-PHY Receiver Test User Guide
Figure
160.