5
HS Tests
Parameters
Dependencies
Results
160
The parameters used in Expert Mode for this test, are as follows:
•
CDR Loop Bandwidth (if CDR is selected in the Special Parameter
dialog, see
"BERT Analyzer
•
CDR Peaking (if CDR is selected in the Special Parameter dialog, see
"BERT Analyzer
Settings")
•
CDR Transition Density (if CDR is selected in the Special Parameter
dialog, see
"BERT Analyzer
•
CDR Loop Order (if CDR is selected in the Special Parameter dialog,
see
"BERT Analyzer
•
Target BER
•
IBerReader Init Mode
•
Test Sequence
•
Re-Init sequence after Reset DUT
•
Lane Under Test Termination Model
•
Tested Accumulated Differential Voltage
•
Tested Accumulated Voltage Range
•
Set Offset
These parameters are listed in alphabetical order in
The calibrations required for this test are as follows:
•
Reference Clock Calibration
•
Level Calibration Terminated
•
Accumulated Voltage calibration Terminated
An example of a HTML Viewer for the Test 2.1.2-HS-RX Accumulated
Differential Input Voltage Tolerance Test procedure is shown in
The results comprise of the following:
•
The common parameter list (in Expert Mode)
•
A test data table (Refer to
Settings")
Settings")
Settings")
Table
21)
Keysight N5990A MIPI M-PHY Receiver Test User Guide
Table
6.
Figure
97.