Test 2.4.5-Sq-Rx Squelch Noise Pulse Wid Th (T ); Pulse-Sq; Purpose; Procedure - Keysight Technologies N5990A User Manual

6 Squelch Tests
Test 2.4.5-SQ-RX Squelch Noise Pulse Width (T

Purpose

Procedure

226
It is available for all hardware configurations.
Figure 137 Test 2.4.5-SQ-RX Squelch Noise Pulse Width (T
It verifies that the DUT does not exit squelch upon detection of an
appropriate Squelch Noise Pulse with duration T
The data generator sends a test sequence consisting of single DIFN pulse
among the DIFP states and it starts with a pulse width less than the
minimum squelch pulse width. The pulse width increases stepwise until
the DUT exits the hibernate state and enters into the sleep state. The Step
Size parameter for this test depends on the HS Gear data rate selected in
the Configure DUT panel (see
when multiple gears are selected.
)

PULSE-SQ

Figure 11) and this test runs at highest gear
Keysight N5990A MIPI M-PHY Receiver Test User Guide
)
PULSE-SQ
.
PULSE-SQ