5
HS Tests
Parameters
Dependencies
Results
180
DSGA)
The parameters used in Expert Mode for this test, are as follows:
•
CDR Loop Bandwidth (if CDR is selected in the Special Parameter
dialog, see
"BERT Analyzer
•
CDR Peaking (if CDR is selected in the Special Parameter dialog, see
"BERT Analyzer
Settings")
•
CDR Transition Density (if CDR is selected in the Special Parameter
dialog, see
"BERT Analyzer
•
CDR Loop Order (if CDR is selected in the Special Parameter dialog,
see
"BERT Analyzer
•
Level Pairs
•
Lane Under Test Termination Model
•
Target BER
•
BerReader Init Mode
•
Test Sequence
•
Re-Init sequence after Reset DUT
•
Min Spec
•
Min Tested Value
•
Max Tested Value
•
Step Size
These parameters are listed in alphabetical order in
The procedures required for this test are as follows:
•
Reference Clock Calibration
•
Levels Calibration Terminated
•
Inter Pair Skew Calibration
An example of a HTML Viewer for the Test 2.1.6-HS-RX Lane-to-Lane
Skew Test procedure is shown in
following:
•
The common parameter list (in Expert Mode)
•
A test data table
Settings")
Settings")
Settings")
Figure
113. The results comprise of the
Keysight N5990A MIPI M-PHY Receiver Test User Guide
Table
6.