Setting Other Trigger Parameters; To Set The Trigger Sweep; To Set The Trigger Coupling - Keysight Technologies 1000A Series User Manual

Setting Other Trigger Parameters

These are trigger system parameters that apply in all trigger modes.

To set the trigger sweep

Trigger sweep specifies whether acquisitions occur without a triggern or only with
a trigger.
1 Press [Menu].
2 In the Trigger menu, press Sweep.
3 Continue pressing the Sweep softkey or turn the

To set the trigger coupling

Trigger coupling is used to filter low frequency signal components or DC offsets
from the trigger path when they interfere with achieving stable triggers.
Trigger coupling is similar to channel coupling (see
the triggering system and does not change how the signal is displayed.
To set the trigger coupling:
1 Press [Menu].
2 In the Trigger menu, press Set Up.
3 In the Set Up menu, press Coupling.
Keysight 1000A Series Oscilloscopes User's Guide
these trigger sweep settings:
Auto Acquire waveform even when no trigger occurs.
Normal Acquire waveform when trigger occurs.
Capturing Data
entry knob to select one of
page 43), but it only affects
3
87