5
HS Tests
Parameters
Dependencies
Results
170
The parameters used in Expert Mode for this test, are as follows:
•
CDR Loop Bandwidth (if CDR is selected in the Special Parameter
dialog, see
"BERT Analyzer
•
CDR Peaking (if CDR is selected in the Special Parameter dialog, see
"BERT Analyzer
Settings")
•
CDR Transition Density (if CDR is selected in the Special Parameter
dialog, see
"BERT Analyzer
•
CDR Loop Order (if CDR is selected in the Special Parameter dialog,
see
"BERT Analyzer
•
Semi Automated Test
•
Set Single Ended Amplitude
•
Set Offset
•
Prepare Length
•
Stall Length
•
Prepare Length Capability
•
IBerReader Init Mode
•
Lane Under Test Terminated
These parameters are listed in alphabetical order in
The calibrations required for this test are as follows:
•
Reference Clock Calibration
•
Level Calibration Terminated
An example of a HTML Viewer for the Test 2.1.4-HS-RX Differential
Termination Enable Time procedure is shown in
comprise of the following:
•
The common parameter list (in Expert Mode)
•
A test data table
Settings")
Settings")
Settings")
Keysight N5990A MIPI M-PHY Receiver Test User Guide
Table
6.
Figure
105. The results