Keysight Technologies N5990A User Manual page 55

Keysight N5990A MIPI M-PHY Receiver Test User Guide
Loop Order
This option is available only for M8020A system configuration. It can be
selected as First or Second order.
Fine Ad just
This option is available only for JBERT system configuration.
Transition Density
The transition density of the CDR can be set from 0% to 100%.
Peaking
The CDR peaking can be selected as Low, Med ium or High.
Input Termination
It can be selected as Balanced or Unbalanced.
Infiniium Settings
For calibrations, Infiniium can be used to add transfer functions to the
oscilloscope channels. Select the Use Infiniium check box to enable this
option.
Other Settings
Reduced Amplitude at Init
If you select the check box for Red uced Amplitude at Init,the amplitude of
the generator is set to the value defined by you at the beginning of each
test procedure, while the generators are being initialized. This is used to
prevent glitches in the generated signal when the outputs of the BERT are
enabled.
Setup procedure in each test subgroup
If you select the check box for Setup procedure in each test subgroup,
the Setup Procedure Pattern is available for each test sub group in the
N5990A User Interface, allowing you to configure the DUT before tests are
started.
Use De-emphasis
If you select the check box for Use De-emphasisis, the generator will send
de-emphasized signals.
N5990A M-PHY Station 2
55