2
N5990A M-PHY Station
30
N4903B + DSGA
•
To use this setup, select JBERT from the Configuration drop-down and
check the Separated Low Speed Generator option.
•
This system configuration works similarly to the M8020A + DSGA
configuration. See section
the system configuration.
DSGA
•
To use this setup, select DSGA from the Configuration drop-down. The
DSGA standalone configuration is only supported for transmitter
testing. It sends the training sequence to the DUT and the actual
testing is performed by the scope app.
•
For any receiver or transmitter test configuration, having a DSGA
enables sending hardware reset signals to the DUT. This allows
seamless transition from one test mode to the next without user
intervention.
"M8020A + DSGA"
for more information on
Keysight N5990A MIPI M-PHY Receiver Test User Guide