Keysight Technologies N5990A User Manual page 235

Keysight N5990A MIPI M-PHY Receiver Test User Guide
7 PWM Tests
Test 2.2.1-PWM-RX Differential DC Input Voltage Amplitude
Test 2.2.3-PWM-RX Common-Mode Input Voltage Tolerance Test
Test 2.2.4-PWM-RX Differential Termination Enable Time
(TTERM-ON-PWM-RX)
Test 2.2.5-PWM-RX Differential Termination Disable Time
(TTERM-OFF-PWM-RX)
Test 2.2.6-PWM-RX Lane-to-Lane Skew
Test 2.2.7a-PWM-RX Receive Bit Duration Tolerance (TOLPWM-RX)
256
Test 2.2.7b-PWM-RX Receive Bit Duration Tolerance, During LINE-READ
(TOLPWM-G1-LR-RX)
Test 2.2.8-PWM-RX Receive Ratio PWM-G1 and above (kPWM-RX)
264
The MIPI M-PHY Specification document defines the requirements for the
M-PHY devices. Refer to introduction of HS Tests for the parameters,
which are included in the M-PHY specification. The test procedures for the
PWM-RX are divided into two sub groups such as:
For J-BERT configuration, the Test 2.2.6 - PWM-RX Lane-to-Lane Skew is
not available.
/ 244
/ 248
/ 260
1 PWM Terminated Tests
2 PWM Non Terminated Tests
/ 236
/ 252
/ 240
/
/