Parameters; Dependencies - Keysight Technologies N5990A User Manual

4 Calibrations

Parameters

Dependencies

102
Figure 58 Connection Diagram for ISI Calibration (for J-BERT + DSGA)
The parameters used in Expert Mode, for this calibration are as follows:
• Lane Under Test Termination Model
• Oscilloscope Bandwidth
• Amplitude
• Jitter Calibration File
• Use Infiniisim
• Transfer Function Chan
• Filter Delay Chan2
• Max Time Span Chan2
These parameters are listed in
No procedure is required for this calibration.
Table 6.
Keysight N5990A MIPI M-PHY Receiver Test User Guide