Use Bit-2100 Switch - Keysight Technologies N5990A User Manual

2 N5990A M-PHY Station

Use Bit-2100 Switch

32
The Bit-2100 Switch can be used in two cases:
1 If DSGA is included in the setup (that is, the Separated Low Speed
Generator Check box is checked), then the switch will be used to
switch between the DSGA and the BERT system. In order to
alternate the input signal, send it to the DUT. Two 2:1 switch
modules are required for this purpose. If a relay switch is integrated
in DSGA, this option must not be selected.
2 If DSGA is not included, the switch will be used to switch across
several DUT lanes. This will allow you to connect and test different
DUT lanes at the same time, thereby reducing the number of
connection setup changes. Two 6:1 switch modules are required for
this purpose.
In order to use a Keysight 2100 Series Switch System for automated
receiver test, the Keysight option 002 (Switch System Support, available
from Keysight as BIT-2001-0002-0), is required.
Keysight N5990A MIPI M-PHY Receiver Test User Guide