Procedure; Connection Diagram - Keysight Technologies N5990A User Manual

Procedure

Parameter Name
Sync Length
Sync Range
TSYNC

Connection Diagram

Keysight N5990A MIPI M-PHY Receiver Test User Guide
The data generator sends Burst-mode CJTPAT signaling while the DUT is
configured for Terminated-mode. In Compliance Mode, the differential
voltage amplitude and the common-mode are set to the nominal values
(200mV). In Expert Mode, two Level Pairs are tested, the differential
voltage amplitude is set to the minimum (60mV) and maximum (245mV)
conformance values while the common-mode is kept to the nominal value
(150mV). It must be performed using the maximum f
ppm. No other signal impairments such as the ISI channel or the jitter
sources are added to the signal.
The duration of HS-Sync Length (T
(symbol interval), where 1 SI = 10 HS and its value is calculated as given in
Table 32. This T
(see Figure 122). At each step, the BER is measured and compared with
the Target BER to consider the pass/fail result. The DUT must be able to
successfully receive bursts whose sync length is greater than or equal to
the RX_HS_Gx_SYNC_LENGTH_Capability attribute.
This test is performed for all selected HS lanes and gears. It is only
required for the Terminated case. In Unipro Test Mode, with the option
"Lane Test Mode" set to Simultaneously, the different lanes are tested in
parallel for each gear.
Table 32 Sync Length values
Parameter Value
0 to 15
0 to 1
IF (SYNC_range = FINE)
T = SYNC_length
SYNC
ELSE (IF SYNC_range = COARSE)
If (M RX or OMC)
SYNC_length 14
T = MIN (2 , 2 )
SYNC
ELSE
SYNC_length
T = 2
SYNC
END
END
Refer to the connection diagrams shown in the Connection Diagram
section of the Test 2.1.1- HS-RX Differential Input Voltage Amplitude Test
test.
HS-SYNC
length is tested over the given HS-Sync Range
HS-SYNC
Parameter Unit
N/a
N/a
SI (1 SI = 10 UI)
HS Tests
value of +2000
OFFSET
) value is measured in SI
5
201