10
Manual Test Procedures
Dependencies
Results
Parameter Name
Result
304
•
Set Single Ended Amplitude
•
Set Offset
•
PJ Amplitude
•
PJ Frequency
•
RJ Amplitude
•
IBerReader Init Mode
•
Check Pattern
•
Lane Under Test Termination Model
These parameters are listed in alphabetical order in
All calibrations must be available before this procedure is run.
Table 57
Setup Procedure Fast
Parameter Description
If the value is "Pass", the values of voltage and jitter are set properly, otherwise "Fail".
Keysight N5990A MIPI M-PHY Receiver Test User Guide
Table
6.