Keysight Technologies N5990A User Manual page 313

Keysight N5990A MIPI M-PHY Receiver Test User Guide
Figure 2
The implementation depends on the instrument setup selected in the
Station Configuration:
M8020A stand-alone
The M8020A is used as generator and to capture the DUT response. It will
send the entire sequence. The DUT must transmit the responses in HS
Continuous mode.
M8020A + DSGA
The training sequence is sent by the DSGA. The M8020A sends the test
pattern and the Frame and Error Counter Request. The DSGA captures the
Frame and Error Counter responses. The DSGA can receive the DUT
responses in PWM mode (Continuous or Burst).
Figure 3 shows the setup required for this configuration.
UniPro Test Mode implementation
Appendix A
9