Xerox WorkCentre 5790 Series Service Manual page 415

B
Connect a service meter at P/J8 between pins 8 and 9. Slowly rotate the ejector motor
encoder. The voltage changes between +5V and 0V.
Y N
Go to Flag 4. Check the wiring and connectors between the ejector motor encoder sensor
and the 1K LCSS PWB. If necessary repair the wiring,
install a new ejector motor encoder sensor,
Perform the 11F-120 1K LCSS PWB Damage RAP, if necessary install a new 1K LCSS PWB,
PL 11.124 Item 1.
Ejector home sensor
Q11-320
Figure 1 Component location
Xerox® WorkCentre® 5790 Family
REP 1.2. If the wiring is good,
PL 11.114 Item 3.
Ejector out sensor
Q11-322
Pulley/drive gear
Ejector belt
Ejector motor
MOT11-020
Ejector motor
encoder sensor
Ejector motor damper
May 2013
2-383
Status Indicator RAPs
11-320-120, 11-322-120